Menu
Your Cart

EarthQuaker Devices - Data Corrupter - Modulated Harmonizer

EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
EarthQuaker Devices - Data Corrupter - Modulated Harmonizer
  • Stock: In Stock
₱13,000.00
Data Corrupter™
Modulated Monophonic Harmonizing PLL
The Data Corrupter is a monophonic analog harmonizing PLL with modulation. It takes your input signal and brutally amplifies it into a crushing square wave fuzz tone that is then multiplied, divided and modulated to create a wild, yet repeatable, three-voice guitar synthesizer.

The Master Oscillator is the central nervous system at the heart of the Data Corrupter’s cyberpunk hive mind. It feeds your input to the signal harvester in its original octave (Unison), one octave down (-1) or two octaves down (-2) for maximum compatibility with your preferred instrument and frequency register. Once you’ve chosen your input octave, then the Data Corrupter will perform its calculations and spit out an analog synthesized frequency, which can be pitch-bent for portamento or vibrato sounds by the Frequency Modulator! From there, you can blend in one of eight Subharmonic intervals up to three octaves below the input and mix in a square wave fuzz tone for maximum data corruption.


Tech Specs:
Dimensions: 5.65 x 4.75 x 2.25 in. (144 x 121 x 57 mm) with knobs
Current Draw: 26 mA
Input Impedance: 1 MΩ
Output Impedance: <1 kΩ

Flexi-Switch® Technology
This device features Flexi-Switch® Technology! This relay-based, true bypass switching style allows you to simultaneously use momentary and latching style switching.
For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass.
For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you release the switch the effect will be bypassed.
Since the switching is relay based, it requires power to pass signal.

Power 
This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES! 


WATCH THE DEMO HERE